Anthony_C
(Anthony C)
August 7, 2013, 2:28pm
1
edit Clay render for the thread preview
Attachments
Nodhorf
(Nodhorf)
August 7, 2013, 2:58pm
2
This is cool, did you planned to make the rest ?
Anthony_C
(Anthony C)
August 7, 2013, 3:05pm
3
Working on it right now. Glad you dig it.
edit original post and render
Flash hider, barrel and front sight gas block.
Enjoy.
Attachments
Anthony_C
(Anthony C)
August 7, 2013, 5:26pm
4
Added barrel nut, delta ring, gas tube and handguard cap
Nodhorf
(Nodhorf)
August 7, 2013, 5:33pm
5
If you made this weapon with the same quality, it should be a really good model of M4/M16 :yes: !
Anthony_C
(Anthony C)
August 7, 2013, 10:31pm
6
Last one for the night.
Lower hand guard just about wrapped up.
Anthony_C
(Anthony C)
August 8, 2013, 12:45pm
7
Lower hand guard and heat shield completed.
Barrel extension and chamber added.
Anthony_C
(Anthony C)
August 8, 2013, 5:14pm
8
Hand guard completed.
Now to tackle the upper receiver.
Anthony_C
(Anthony C)
August 8, 2013, 10:19pm
9
Took a break from modeling to start working on the materials.
That’s all for today. Tomorrow I’ll start the receivers.
Anthony_C
(Anthony C)
August 9, 2013, 4:32pm
10
A few more small details (forward assist and dust cover) to take care of and the upper receiver will be finished.
aosfilms
(aosfilms)
August 9, 2013, 6:03pm
11
Wish I was capable of this kinda accuracy. Good stuff.
Anthony_C
(Anthony C)
August 10, 2013, 9:15am
12
Aosfilms, thanks for the kind words. Just keep at it and you’ll get there. Lots of good stuff around the net to help you along.
Forward assist and dust cover assemblies in, take down pin mounts in and receiver is treaded.
Call this part complete. Next up, charging handle and bolt carrier assembly.
Anthony_C
(Anthony C)
August 12, 2013, 9:07pm
13
Went back and reworked a few areas of the hand guard, much happier with it now.
Anthony_C
(Anthony C)
August 13, 2013, 11:37pm
14
Finally finished with the upper.
Anthony_C
(Anthony C)
August 14, 2013, 2:11pm
15
And with the upper completed I am back to figuring out materials.
Anthony_C
(Anthony C)
August 14, 2013, 10:34pm
16
Last one for the night. Still not thrilled with the materials but they are getting closer.
Anthony_C
(Anthony C)
August 15, 2013, 8:22am
17
For hoots and hollers I gave the toon shader a run this morning.
Kind of cool. I am thinking a blue print of the completed rifle would be really nice.
Can any of you that do blue printing point me in the right direction?
MonkMonk
(MonkMonk)
August 15, 2013, 9:31am
18
I’ve never done a blueprint render. But if you use freestyle with white lines and place it on a blueprint background it should work. Lots of detail on this, well done.
Anthony_C
(Anthony C)
August 15, 2013, 9:35am
19
Thanks Monk, I’ll give that a go.
IconW
(IconW)
August 15, 2013, 10:00am
20
Looks really good! Love the level of detail.