Attached Blend File:
bevel.blend (102 KB)
I’m having trouble with an edge that has a bevel weight on it.
You can see the problem in the image below.
On the left side of the model you can see how the bevel “curls up” over the corner of the plane. On the right side, everything is fine. If you tab into edit mode you will have the 2 edges in question selected (the good one and the bad one that have bevel weights).
The topology is pretty much identical on both sides, though not precisely identical.
There are creases and bevel weights on various edges.
There are 3 modifiers: Bevel, Mirror, Subdivision, in that order. I tried messing with the order with no success.
I just can’t figure out what is causing the bevel to act so differently with almost the exact same topology.
Any help would be appreciated.
Thanks all!
