How can I model this shape?

Ive been trying for some days to models this very basic shape, but I cannot seem to get the right dimensions or parts.
Its the base of this Lego castle Im talking about.


And heres what I got so far.




Don’t extrude too early. Start with a plane and begin laying down edge loops every-where you see an edge in your reference. With everything still flat now extrude up. And translate (grab/move) the edges around to make the ramps. The little notches or footholes around the perimeter can be done afterwards with deleting faces and using the F to fill in. For the lego ground connections model 1 of those then use arrays for placement. Apply and join all together. My two cents.

similar to said above, subdivide a plane to the number of lego “units”, and work off that. i would even shift-d all the faces up as layers, then create side faces, not the best way, but a way nonetheless. simplify and dissolve at the end.




Thanks for your replys, I think I nailed it pretty well :slight_smile: