Hello,
I was doing the tutorial from blender nation about the ink drop.
But when I am in the flow menu and adjust the settings, then I have to go to domain to activate sooe settings
When I return to the flow tab my settings are gone again and the are back in defaukt settings?
Is this normal?
I also don’t have a cloud when the uvsphere comes in the water
Is this a blender problem??
This is the link
Gabz writes: In this blender tutorial, of the Animation & Physics series, we see how to create a drop of ink in the water. We use the smoke system that blender provides to create this beautiful ink effect. Thanks!
GrimZA
(Armand)
April 27, 2017, 10:51am
2
It’s not a blender problem, select the large box if you want to adjust the domain and select the ink drop when you want to adjust the flow.
Hello,
No even when the sphere that represents the ink has selected and i go domain and go back to flow it keeps going back to default
GrimZA
(Armand)
April 27, 2017, 12:04pm
4
That’s normal behavior. You should not have to go to domain settings with the sphere selected, only flow settings. Any settings you want to change to the domain, you will have to select the cube which represents the domain.
But hen is the problem, why don’t I get the smoke = the grey in the water
GrimZA
(Armand)
April 27, 2017, 2:48pm
6
Upload your blend file so i can take a look.