It is possible to create curve with adaptive resolution or separately control resolution of each point?
1 Like
Number of segments are constant between the control points.
The current setting applies to the whole curve, not per individual control point
Select your Curve.
Convert to Mesh (Alt+C)
X -> Limited Dissolve
Convert to Curve (Alt+C)
Optional: Check Spline Type - Toolbar->Curve Tools->Set Spline Type (in Edit-Mode)
Make your Extrude.
1 Like
Use vector handles on the straight bit.
Was looking for the same thing (4 years later). It’s something I’m missing after coming from 3ds Max. If I find a simple way to do it I’ll respond to this thread in case anyone else lands here like I did.
2 Likes