i carefully put the cursor on the centre line when i spun this cube.
but as you can see, no matter which ‘origin’ i choose, it wont rotate evenly.
as you can see position one is close to the temporary block i use to check it.
position 2 is not the same.
i need to rotate the 14 blocks so there not alop!
thanks all
PS any version should be able to do this. i use an older version cause i got tired of not knowing where thing were every time they change everything. and it will suit my simple requirements
yes guys i know it spins around the cursor which i why i was VERY careful where i located it. x0, y0 z-5. the object was at o o o
i used the spin tool.
thanks
Ricky “sorry but then what is the problem
spin duplicate should give very precise location function of the center with cursor !”
if it did that i would NOT have been writing!
Lane - it did not change things for me.
please guys download the file and see it live!