I am looking for an experienced modeler willing to work quickly, efficiently, and able to iterate on the design of each model until it is in a completed state. There will be several small models created specifically for 3D printing. We will be using the OpenLock system as a basis, which provides templates for our pieces that must be used. A portfolio of your work is necessary, PM the details.
Requirements:
- Experience in creating models for 3D printers
- Able to work to exact size specifications for models.
- Able to take feedback and adjust the design of each model accordingly.
- You must be able to use dropbox.
- You must be responsive and able to work to established deadlines.
Preferred experience (Nice to have, but not necessary):
- Experience with OpenLock system
Pay:
- I prefer to work with a modeler on an hourly basis, and within a set amount of hours.
- If hourly, you will be paid every Friday.
- If project based, the cost of the project will be sent upon delivery.
The Project:
- Norman-style architecture. Reference “Rochester Castle”
- There will be a minimum of 15 models, perhaps more. No model should take more than 3 or 4 hours to complete.
- Direction will be provided for the textures desired for each surface & object, but the artist is allowed freedom within that framework.
- Floor pieces will be 50.8mm square with a base height of 7mm The height may be slightly higher with sculpting.
- Wall pieces will be 57.8mm square with a base width of 7mm. The width may be slightly wider with sculpting.
- Deliverables must be a STL files that fit supplied specifications.