good afternoon all, i am currently testing for my dissertation, i need some help if anyone can help, i am putting cycles up against vray to gather some data, but to keep the data fair i need to set vray up to have settings that match cycles settings. could anyone advise me on how to go about doing this correctly as information on the subject is sparse at best.
my usual cycles settings are
SAMPLING
path tracing
clamp direct 0
clamp indirect o
light sampling 0.01
render 100
LIGHT PATHS
transparency
max 4
min 1
bounces
max 4
min 1
diffuse 4
glossy 4
Transmission 4
volume 0
shadows yes
reflective/refractive caustics off
if anyone could help shed some light on how to transfer even just the sample rate to vray for either path tracing OR branched path Tracing i would be grateful
thanks in advance 