There is something off with the proportions when I compare with the references. Try making the shoulders wider and the head a little bit smaller.
Also, the references are always shown in a pose where the legs are a bit spread outward, so that will be important for the character to look authentic, though you may need to rig the model before this can be fixed.
I can also mention there is a difference in the position of the hand within the wrist joint. In the references, the handâs top is more aligned with the top of the wrist, which leaves space for the thumb (which is angled downward, unlike the way you have done it on the same plane as the other fingers).
i think i fixed the head
for the wrist tehyre is actually no joint sincei couldnt fidn a way to make it look good so i just hide the end of teh hand inside of the arm hole
for the shoulder honestly i dunno how to really edit them without butchering the model but its true on a second look he his probably not bulky enougths
Couldnât you select the shoulder ring and use proportional editing to move it out a bit? If you adjust the radius well, it should be possible without affecting the neck piece.
Maybe my explanation wasnât clear, here is a rough example of what I mean:
The whole hand moves to the upper part of the wrist hole. The thumbâs base is angled compared with the palm, it even is a separate piece in many of the images.
so i tried to tweak the shoulder but it wasnt very good so im probably gonna keep it liek that .
For the hand i dont really see the hand being closer to the tube but i do see what you mean on teh fact some reference have the thumb base having is fully separate part witch is something i should probably have gave more thought too it.
after a bit of thinking maybe uinternal mechnical part is over doing it
welp started to do some retopo
can i help you modeling?
dont really think so,
I mean other then not seeing how people can work at once on the same model,that would probably go against learning more how to improve my model quality and optimisation.
20 000 triangles isnât so bad. Itâs completely fine for a render, a modern game engine could even take that with some LODs.
i mean its 20k just for the big part of the torso not even the full model + its pretty hard to unwrap model with alot of tri (but i might be just laking in experience)
I would say 100k for a whole character is fine on modern hardware for high quality work. It does depend on the intended use though.
probably for a bit of everything , render , animation , game that could i hope run on not so good hardware
need leg taller
nice modeling







