It wants to pull the poly the opposite way. where do I put an edge loop to relieve the tension?
Hi,
Have a good read of the following URL:
http://www.lightwiki.com/Fundamentals_of_Subpatch_Modeling_Part_Two
Helped me loads. Not a Blender tut but holds true none the less.
Kindest Regards,
Pixeltwister.
P.s the green line represents the loop cut you need…
Attachments
Thanks that was an interesting read. I`ll have to study that. as to the car, I just started again… lul. but I will bear that in mind for future. thanks.