hi blenderhead
i have problem with fluid size. I want make a fluid flow into a pipe. I set the pipe as obstacle and set the the fluid with inflow. Fluid and obstacle using shell mode.
[ATTACH=CONFIG]203935[/ATTACH]
I use default setting for all, but when i try to bake, on the first frame the pipe is full :spin::spin:. Look like this
[ATTACH=CONFIG]203936[/ATTACH]
I don’t know why, maybe you know the solution?
i think size of fluid same with size of domain. If i set the domain big, so the fluid will be big too, where i can set the size of fluid?
Hey I can’t open your attachments but… You need to probably increase the fluid domains “real world size”, I think it assumes that the longest side of your domain cube object is the length (in metters) you set. The scaling in blender units has no effect. Then of course the higher simulation bake resolution you use the better results you will get. If you use too low baking resolution you end up with bulky thick looking thing, which don’t cooperate well with too small holes etc.
Thank you, you’re right. Size of fluid can set on real world size.
New problem, sometime when i bake the fluid. Nothing happen in domain. Do you know why?
