Begginer- Need help with modelling a shape

Hello, I need some help modelling this top part liquid dispenser. I have viewed several tutorials on modelling, i can get basic stuff modelled but I’m stuck with this one. Any help i would appreciate. Here it’s how it want it to look.

belnderhelp

It’s the very top part.

How do you want me to answer? I could whip one up for you if you want. What I’d do is extrude up a cylinder, then extrude again and pull it down, using proportional editing to pull it into the teardrop shape, then extrude this up and fill in the top, before finally insetting the faces in the front and extruding them in to make the little dispensing hole. Then subsurf + support loops to tidy it up for hard surface.

There was a similar thread a while back that might have some tips