Blender -> DXF -> Vecta3D --> Shockwave Files

Support Basics & Interface
1

Hi everybody,

I’m using Blender since a long time but on a really low level.
Mostly to produce simple DXF models witch I usually open in Vecta3D to get shockwavefiles out of it. Normally this works fine :stuck_out_tongue:

Here is the problem: :-?

While saving DXF from Blenderfiles with textobjects the text is not included in the DXF-File.
Is there maybe a special mode of text wich is supported by DXF?

Is there anybody who knows something about this problem?
Any suggestions?

Hopefull with the best greetings to the whole Blender Community

Frank

2

Alt-C convert to curve, Alt-C again convert to mesh

3

Hi mthoenes,
exactly what I needed !!!
Great answer short and precise.

Thx Frank :wink: :smiley: :slight_smile: 8)