Curve Deform problem

[greyoxide]

I have a walkway that I am trying have run parallel along the pipe [http://img38.imageshack.us/img38/9900/needhelp.jpg[/IMG] Shot at 2009-06-10"] Shot at 2009-06-10]([IMG)

So far everything is fine until I try to add start and end caps. The end cap goes on no problem but the start cap has this huge space between it and the rest of the walkway.

[http://img44.imageshack.us/img44/3230/needhelp2.jpg[/IMG] Shot at 2009-06-10"] Shot at 2009-06-10]([IMG)

The outside walkway has all of the same settings as the inside walkway minus the start an end caps, and its fine.

What am I doing wrong? I checked the source mesh for the start cap thinking that maybe I just had a stray vertex out there by itself but I found none. That and I didnt move the mesh around that much so it’s more likely I screwed up a setting.

here is a picture of the modifier stack for the inside walkway
[http://img189.imageshack.us/img189/2720/modifierstack.jpg[/IMG] Shot at 2009-06-10"] Shot at 2009-06-10]([IMG)

any help would be appreciated.

Thanks,

[Vertex_Pusher]

Either increase the number of array count to something higher or use the Fit to Curve Length option (hit the “Fixed Count” name field) or the Fixed Length option and input the length that works for you .