Fixing A Mesh So Smooth Surface Works

Support Modeling
1

I separated a section of the mesh I was working on so I could move some parts around without proportionally editing parts of the mesh I wanted left alone. When I bridge the edge loops back so everything’s connected I can’t figure out how to get it “clean” again and Shade Smooth doesn’t look right.

You can see the section I rejoined in wire frame view mode.

Temp%20File
Temp File.jpg1533×749 252 KB

2

CTRL+N to reset the normals

3

Thanks! Just came back to post that I found the fix and now I know the keyboard shortcut for it.

1 Like