Hi,
Is it possible to add a force field to a fluid simulation?
I want to create a fluid rotating around it’s Z-axis like in a mixer.
I tried to add a force field (vortex) to the domain and later also to the fluid.
But if I bake it, the fluid does not rotate at all.
Any ideas?
Thanks!
I think fluids only work with obstacles. I could be wrong…
But you could make an inverted cone (make it an obstacle) and place it in the center of your domain. This should keep fluid from the center. Then perhaps a creatively placed inflow to make it spin…?
Just brainstorming here…
it sounds logical… must try it.