Hello everyone!
I´m new to this forum (registered yesterday) and would like to say hello to you all while giving you a mission. I have a problem (who doesn´t). It´s about joint orientation. Is there a way to rotate the axes without affecting the armature? When setting up constraints these little critters gives me a headache!
Thanx!
Daniel
You can affec the roll of the bones in edit mode through the Nkey (properties) panel or with the Ctrl-N combo (recalc roll).
Martin
Thanx man! Will try that.
I´m damn close to the almost perfect rig, and the tip you gave me put me closer. Thanx again. Maby I will post it here in the near future. Well, time to go to bed. Have to get to work in four hours.
Goodnight!
Daniel