[topic was named ““Cutting through steel” using curved letters?”]
Here is a link to a zip file that shows the problem:
http://members.ozemail.com.au/~wenke/blender/writing-test.zip
Basically the word I drew using curved letters is hi-res, but the particles only go on a low-res version of the curve… is there any way to get the particles to go on the hi-res curve?
Also, what would be the easiest way to make it draw one letter after another? (Separate paths I guess) If there were separate paths then would it be possible to have a “pen” or a spark that writes it?
Thanks.