Sculpting: brush symmetry not working properly Just on the lower part of the model

Support Modeling
1

Top down until that last ring I was able to brush stroke them evenly as seen in the pictures. On the lowest one for some reason the strokes weren’t going all the way on the 45 degree ones and when enlarging the brush it did stroke but at uneven width.

Then I went back up and brushed the one ring up and it was fine went back down still didn’t work no matter which brush I used and normal orientation is correct.

A very weird problem.
What’s the reason for that. How to solve it.

Every comment is very appreciated.

SCULPTING ISSUES - STAFF 001
SCULPTING ISSUES - STAFF 0012560×1365 715 KB

SCULPTING ISSUES - STAFF 002
SCULPTING ISSUES - STAFF 0022560×1365 1020 KB

SCULPTING ISSUES - STAFF 003
SCULPTING ISSUES - STAFF 0032560×1365 1.03 MB

SCULPTING ISSUES - STAFF 004
SCULPTING ISSUES - STAFF 0042560×1365 809 KB

2

Have you checked that your mesh is actually symmetrical? If there’s a few random verts or edges thrown in somewhere then it will get completely thrown off. Try symmetrizing your mesh on every axis and see if that fixes it. Also make sure scale and rotation are applied correctly.