simple mask need done on blender.

Jobs Volunteer Work
1

i have a mask i need done on blender, its simple, please help

photo.JPG901×2048 317 KB

2

I’ll give it a shot. Might not be done too soon.

3

Are there any specifics to the request other than getting the mask done? Is it going to used somewhere?

4

alright cool, thanks :slight_smile: how long do you think it would take?

5

Hey, I gave it a shot but didn’t model the eye slits, it was complicated. I think they could be easily textured on to look good though. Anyway, here’s the blend file.
If you still need help you could always PM me, but like Fitzoperfecto I also think you should be more specific when requesting things.

Helmet.blend (500 KB)

6

sorry ill try and be more specific, it needs to look like it would be wearable, so the walls of it need to me kinda thin. im looking to get this 3D printed, and they need an acurate model, ill check yours out now though.

7

sorry ill try and be more specific, it needs to look like it would be wearable, so the walls of it need to me kinda thin. im looking to get this 3D printed, and they need an acurate model, Nivos you did a good job thanks :slight_smile: if you could make the top a bit flatter it would be great, and is there anyway to make the walls thinner, like half as thick as they are now?

8

I’ll see what I can do, but if it is to be 3d printed then the slits can’t be textured in.
Are they necessary to the design? If so I will try and model them as well.

9

Well, here’s what I have so far. The slits are difficult(for me) to model so if you do need them, please say so.

Helmet.blend (531 KB)

10

not sure if you talk of mask as same thing but here…

mask.JPG308×700 19.6 KB

11

Sorry, I should have read everything to know
what was the project really about.

12

yes they are necessary to the design, if you can please add them

13

HELMET6.blend (393 KB)

Attached mask is which Nivo did with holes.

14

Here’s my progress so far, there is some slight pinching at the slits’ ends.
I’m assuming you will be exporting to obj for printing? If so make sure to bring the exported model into blender and, in edit mode, select all vertices, and press W/Remove Doubles or the Remove Doubles button in the tool shelf to create an airtight model for printing.
Anyway, if there is anything else you need done on the model, be sure to let me know.

Helmet.blend (541 KB)