Spot lights cut off...

Support Basics & Interface
1

Sometimes the projected lights of the spots
over the floor appear ‘cut off’ on the circle of
light, revealing one side completely straight,
as if the light projected was, precisely cut off.

A good -and simplified- example is this:

http://perso.wanadoo.es/juanj_video/cutoff_light.jpg

Which are the parameters relevant to this?

Hope you can see it and shed ‘some light’ :wink:

Greeetings,

Juan Javier Martínez.
Madrid, Spain.
www.juanjaviermartinez.com

2

I think you need to increase the Distance value. I’m not sure, running on very little sleep, so I don’t remember much.

Edit: Or try ClipEnd.

3

It’s the clip end value. The lamp’s clipping is shown as a solid line in the spot lamp.