Ultimaker 2+ Connect Release Presentation

Hi everyone,

A very short deadline but quite proud to have been chosen to do this project. It was completely done in Blender which was a total blast and so much more fun and stable than the software i’m used to.

4 Likes

And you should be proud, that came out good. If thats your voice as “narrator”, your lucky, wish i sounded like that.

Haha thank you.
And i wish.
The voice over was done by someone who does that for a living.
He did a good job.

Was the filament a fluid simulation?

It’s an animated curve that follows the cable.bowden rig attached to the print head. A fluidsim for this would make things a lot more cumbersome i think.