i’v joint all the nurbs curves OK
then i edit mode shift - F
but this did not get the last nurbs and it did not put surface only edges
What did i do wrong for this skinning :evilgrin: :evilgrin:
Tanks & Salutations
Are you talking about Surfaces? The hotkey is F, not Shft-F, and then Endpoint U (and endpoint V depending on the structure).
%<
right not shift f but f alone
that seems to correct the thing
But How do you that the endpoint in U and V have been selected?
no change in color
Tanks
NURBS use Weighted Averaging (see the bottom of the CurveTools tab); the shape and position of the Curve is Relative to the Averaged Weights of the Control Points. The end (or beginning) of a curve is therefor defined by the Average weight of the last two control points. When you click ‘Endpoint U’ the end of the Curve is connected (anchored) to the last control point in the U direction and the Position is no longer affected by the weight of that control point but by the weight of the control point second to last. In a 3D Surface the same applies to the V direction.
%<