Wire and roots into shape

Support Modeling
1

Hi

Is it possible to make wire and roots that fallow over geometric shape or and inside the geometry,
something like below?


2

you could use hair particules and comb it like this!

salutations

3

Any tips how i can make hair particle run around surface?

4

could maybe try the ivy gen (under curves if you have it enabled) turn off leaves then mess with settings
it can/does follow shapes quite well but I haven’t tried it on anything as complex as what you want

5

The ivy gen looks very nice, thx. BTW how can i make ivy to cover more of the geometry. Now it’s around bottom of my object?

6

Here are some values which might help. You can write value on slider, which otherwise limits them.
http://www.pasteall.org/pic/42914

7

Thx for tip eppo.