Imagine a plain, you want to create 2 loops, one on the top, one on the bottom, that are each 10 cm from north/south edge (end edges as I’ll call them). Like this:
Is there a way to do this with just the slide loop (2 x G) option somehow or do I need to select the vertices of the edge loops, then move them in the same position as the end edges and then move them again 10 cm’s away from those end edges?
If I create a loop and move it to a 0.9 position and then create another loop and move it also to 0.9 towards the opposite end edge, in the end they are not equally far from their end edges, for example one is 9.5 cm from the end edge, while the other is 9.9 from the end edge, but I need them to be exactly 10 cm.
This would be extremely useful for creating holes without using boolean. I think that Bevel also uses the same unit logic instead of regular cm (or inch,etc.) units.
Also, speaking of boolean, is there a way to use boolean and create a hole, but have the holed out polygon remain in quads, instead of adding tri’s and creating a ngon mess? As you can see in this example I got 2 random edges, one even goes in the middle of the hole for some reason and I get ngons… I painted in red something that would make more sense to me.