Close areas sticking each other after the remesh

Support Modeling
, , , ,
1

Hi guys when ı use remesh close areas sticking each other. How can ı fix this?

I tried to add a picture but the website does not allow.

pls check this link

1 Like
2

Thats voxel remesh for you!

What is happening is that the smallest voxel is bigger than the smallest gap.

A couple of three things you can do,

  1. try adaptive remesh,

  2. rig, or use sculpt mode grab tool and make the spread of the fingers alot larger so they are further apart from each other.

  3. detatch the fingers and hand, and remesh separately.

Hope that helps…

3

second one is good

2 Likes
4

I know this is an old post, but for new people, one trick is to sculpt both geometries separately and remesh them separately, and then join them at the end with boolean modifier, and then you can clean up the seams.