hi there…
i have imported this illustrator curve of a star,
when i have extruded it i can see it not closed
in front and back (no caps).
how can i extrude the curve with caps?
thx in advance…
/schioler
Sometimes when you import curves, they can be quite messy. I’ve had some issues with using fonts in this manner.
Normally a closed curve should automatically fill.
Perhaps the curve isn’t properly closed and the ends are just sitting next to one another.
Pull the curves contol points around a bit to see if this is the case ie, select, drag, Right click or press [Esc] to cancel. If you find an opening, ensure that at least one control point on the curve is selected and press [c] to close.
thanx a mill, ill try to check out the curve right away!