Follow path, How to make the object do more cycles than one in a closed curve?

Is it posible to make an object that is following a path to do more cycles than just one?

If the path lenght is set to 20 frames , and my path is a car running in a circuit and i want the car do do many cycles and not just one and that it ends at 20, how do i do that?

Open up a Path IPO curve and set a speed curve then set the speed curve’s Extend Mode to Cyclic . If you don’t want it to do this eternally just copy the cyclic pattern into the curve like this :


curve_cycle.blend (156 KB)