GeoNodes: Procedurally Auto Aligned Bezier Curve

Support Modeling
,
1

Hopefully this is simple and I’m just daft. I want to apply GeoNodes to a faceless Plane, convert that plane from Mesh to Curve, then set the curve AND/OR its handles to Aligned/Auto Bezier so that everything gets rounded.

There are rather a lot of “Set Spline Type” and “Set Handel Type” and “Set Handle Position” etc. nodes, but I can’t get the bloody curve to do anything whatsoever.

Am I daft?

Capture
Capture1496×1465 143 KB

2

#HeadDesk -ing so hard… Not 30 seconds later and I bumble my way into the solution. Mesh to Curve → Set Spline Type (Bezier) → Set Handle Type (Auto): PROFIT.

Capture
Capture1758×1582 205 KB