Greasepencil offset stroke dots

Is there a way to offset the dots on a greasepencil stroke? You can change the spacing, but it would be useful to also have control over the offset, particularly if it could be animated.

Below is me animating the spacing, which causes the dots to move along the line. This gives you an idea of the effect, where the stroke dots are moving except that this changes the spacing so eventually the dots end up too far apart or too close together.

The Dot Dash modifier has an Offset field above the segment list, and it’s animatable. It shifts where the pattern starts along the stroke without touching Dash or Gap, so the dots slide along while their spacing stays fixed.

  • Offset is counted in stroke points, so the dots move one point per step, and the pattern repeats every Dash + Gap points. Negative values move them toward the end of the stroke, positive toward the start.
  • For continuous motion, right-click Offset → Add Driver and set the expression to -frame.
  • If the steps look too coarse, put a Subdivide modifier above Dot Dash so the stroke has more points, then raise Dash and Gap to keep the same spacing.

I checked it in 5.2 on a 40-point stroke with Dash 1 / Gap 4: Offset -1 moved every dot exactly one point along, and the spacing didn’t change.