Modelling one difficult part of a car (1970 Chevrolet El Camino)

How do I get this part of the side door of the El Camino correct? I have difficulties in getting it right

can you elaborate !

what do you have done show some pics

and clarify the problems

happy bl

Look closely at the upper right corner of the door panel of the Chevrolet El Camino SS:

My low-poly model does not match that one corner of the door panel:

This is that one corner of the door panel as projected from top view:

I cannot seem to get that area right because there is a slight ridge between the window and the door and that ridge continues to the front fender of the car.

Front Blueprint

Side Blueprint

Rear Blueprint

Top Blueprint

These are the blueprints I used

how did you do the door hole ?
did you use the shrinkwrap modifier ?

happy bl

Without the door it should be easier to see the detail.

You can separate the door mesh, or you can leave it a single piece, but in this case, you have to make the edge continue through the door’s panel.

Thanks for the help