Hello, I’m sorry if I miss smething obvious but I’m new with the particle system and can’t fifure out why my render looks so different from the viewport.
this is expected
this is the render
and my settings
Thank you for any suggestions.
Hello
Are you using cycles?
Couple of places to check:
Render display vs the Render settings in particle tab - make them the same amount of steps:
Curves section in Render tab - make them the same subdivisions (not like here):
Hope that helps.
1 Like
Hello, it was indeed the number of strand steps that was causing this havoc. Particle settings can be hard to get used to. Thanks!