Rendering 360° and stereo VR panoramas in Blender for virtual tours (settings that actually work)

I’ve been rendering a lot of interior panoramas for walkable 360° tours lately, and the same few settings keep tripping people up. Here’s the checklist I use.

1. Camera

  • Render engine: Cycles (the panoramic camera is Cycles only).
  • Camera > Lens > Type: Panoramic, Panorama Type: Equirectangular.
  • Keep the camera perfectly level (X rotation 90°, Y 0°). Any tilt bends the horizon, and the floor right under the camera warps badly.
  • Height: around 1.5–1.6 m for interiors. Lower feels like a child’s view, higher feels like a drone.

2. Resolution

  • Always 2:1. 8192 x 4096 is a good default; go 16384 x 8192 only if you’ll actually let people zoom in.
  • Keep the noise threshold a bit lower than for a still. Viewers look at every corner, including the ceiling.

3. Stereo for VR headsets (optional)

  • Output Properties > Stereoscopy: enable it, Stereo 3D.
  • Camera > Stereoscopy: Mode Off-Axis, Interocular Distance 0.065 m, and turn on Spherical Stereo.
  • Output > Views Format: Stereo 3D, Stereo Mode: Top-Bottom. You get one image with the left eye on top, right eye below.
  • Set the Pole Merge angles (around 60° to 75°) so the stereo effect fades out straight up and down. Without it you get eye strain at the poles.

4. Before you build the tour

  • Render every room from the same height.
  • Point the camera’s -Y toward what you want people to see first. It’s easier than fixing the opening view later.
  • Save as JPG at high quality for the tour itself; keep the EXR if you’ll need to regrade.

Then load the panoramas into any 360 viewer or tour tool and link the rooms. Full disclosure: I work on Prewalk (prewalk.co), a browser-based tour tool, and this is the exact workflow we recommend there. The settings above work with any viewer though.

Happy to answer questions or look at a panorama that comes out warped.