Rigid Body simulation issue

Support Particles and Physics Simulations
1

Hi,

I got a problem with the Rigid Body simulation. Both my belt and box has the rigid body on in the physic tab with my belt as passive and my box as active. However, my box always seems to either pass through the belt, jump off, fly off or float along with the belts origin. I tried to change the calculations of almost everything; This is what I have tried so far.

  1. Changing the calculations on Sensitivity> Margin
  2. Changing the calculations on Surface response > Friction.
  3. Changing collision source to final for belt
  4. Uncheck and checked the deforming.
  5. Changing the steps per second. Tried 10 to 1000.
  6. Changing the mass of the box.

Below pics are a example of what I am facing.

Screenshot 2020-02-17 at 10.54.45 PM
Screenshot 2020-02-17 at 10.54.45 PM3350×1890 769 KB

Screenshot 2020-02-17 at 10.55.06 PM
Screenshot 2020-02-17 at 10.55.06 PM3358×1892 773 KB

Screenshot 2020-02-17 at 10.55.16 PM
Screenshot 2020-02-17 at 10.55.16 PM3356×1892 783 KB

Screenshot 2020-02-17 at 11.12.56 PM
Screenshot 2020-02-17 at 11.12.56 PM3352×1890 788 KB

Screenshot 2020-02-17 at 10.57.07 PM
Screenshot 2020-02-17 at 10.57.07 PM3360×1892 751 KB

Thank you in advance.

2

HI, have you tried changing the box origin to the base of the box?

3

Thank you for your reply.

I just tried that after seeing your reply but it still didn’t work.

4

If you can post the file i will have a look at it.

1 Like
5

Hi,

I was playing around with it again today and I found the problem. I forgot to apply the array modifier for the belt that’s why the rigid body didn’t work.

But thank you so much once again.

1 Like