setting opacity of xray mode and setup hotkey for running multiple command at once

Support Basics & Interface
1

  1. i turn on ‘limit selectin to visible’ or x-ray mode. Where is the setting so i can adjust the transparancy value ?

  2. How can i custom my shortcut to be able to run multiple command. So i want to fire up couple of commands in a single hotkey. How can i do this ?

Thanks

2

  1. There’s no actual transparency. The occluded edges are just drawn on top of your geometry at ~ 50% opacity. I’m not aware of any way to change the value of the edges.

  2. Try this addon. After you create an operator, you should be able to assign a hotkey to it.